2006-2011 Camry Aurion · Service Manual BRAKE

ADJUSTMENT

Removal / installation · Vehicles built from Jun 2006


1. CHECK AND ADJUST BRAKE PEDAL HEIGHT

  1. C132713E01
    Check the brake pedal height.

    Pedal height from dash panel:
    Model
    Transaxle
    Specified condition
    LHD
    Automatic
    129.9 to 139.9 mm (5.114 to 5.508 in.)
    Manual
    131.9 to 141.9 mm (5.193 to 5.587 in.)
    RHD
    Automatic
    135.5 to 145.5 mm (5.335 to 5.728 in.)
    Manual
    137.5 to 147.5 mm (5.413 to 5.807 in.)

  1. Adjust the brake pedal height.

    1. Disconnect the connector from the stop light switch assembly.

    2. Remove the stop light switch.

    3. Loosen the push rod clevis lock nut.

    4. Adjust the pedal height by turning the push rod.

    5. Tighten the clevis lock nut.

      Torque:
      26 N*m{ 265 kgf*cm , 19 ft.*lbf }

    6. C111301E03
      Insert the switch into the adjuster until the switch body touches the pedal.

      NOTICE:
      Do not depress the pedal.

    7. Rotate the switch a quarter turn clockwise.

      Torque:
      1.5 N*m{ 15 kgf*cm , 13 in.*lbf } or less

      NOTICE:
      Do not depress the pedal.

    8. Connect the connector.

    9. F043108E08
      Check the switch clearance.

      Standard stop light switch clearance:
      1.5 to 2.5 mm (0.059 to 0.098 in.)


2. CHECK PEDAL FREE PLAY

C132708E01
  1. Stop the engine. Press the pedal several times until no vacuum is left in the booster. Release the pedal.

  1. Depress the pedal until a slight resistance is felt. Measure the distance as shown in the illustration.

    Pedal free play:
    1.0 to 6.0 mm (0.039 to 0.236 in.)

    If the pedal free play is not as specified, check the switch clearance in the next step. If the pedal free play is as specified, proceed to the "CHECK PEDAL RESERVE DISTANCE" procedure.

  1. Check the switch clearance.

    Standard stop light switch clearance:
    1.5 to 2.5 mm (0.059 to 0.098 in.)

    If the clearance is not as specified, reinstall the switch and recheck the pedal free play. If the clearance is as specified, troubleshoot the brake system and proceed to the "CHECK PEDAL RESERVE DISTANCE" procedure.


3. CHECK PEDAL RESERVE DISTANCE

C138215E01
  1. Release the parking brake pedal or parking brake lever.

  1. With the engine running, depress the brake pedal and measure the pedal reserve distance as shown in the illustration.

    Pedal reserve distance from the dash panel at 500 N (51 kgf, 112 lbf):
    Model
    Transaxle
    Specified condition
    LHD
    Automatic
    61 mm (2.402 in.)
    Manual
    63 mm (2.480 in.)
    RHD
    Automatic
    65 mm (2.559 in.)
    Manual
    67 mm (2.638 in.)

    If the distance is not as specified, troubleshoot the brake system.

← DISASSEMBLY (from Jun 2006)REASSEMBLY (from Jun 2006) →